These coils were made by the master himself! – – – FRAMED STAPLE COILS – an original concept by @squidoode
This listing is for two (2) Framed Staple Coils made by @squidoode. These coils were made with 6 pieces of stacked 0.5mm/0.1mm Kanthal-A1 Ribbon wire with 2 pieces of 26g Anarchist Competition (26AN80) wire on each side fused together with 36g Nichrome 80 (36TMN80) and are approximately 0.13-0.19ohm each (single coil resistance). This coil takes the best performance aspects from the Fused Clapton and the Staple Coil.
Buying a set of these beauties is a great way to show support to Ryan (@squidoode) and help him get his future projects off the ground.
If you want to try making these yourself, 36g Nichrome 80 is available on www.twistedmesses.com and make sure to check out Ryan’s “Staple Coil” YouTube tutorial found on his channel “The Art of Vaping” (embedded below)
NOTE: Resistance will vary depending upon lead length and Atomizer-Post composition. Copper center post will cause slightly lower resistance and the shorter the leads (closer the coils are to the atomizer) the lower the resistance will also be.
WARNING: These coils are intended for persons over the age of 18 and only intended for those people with extensive experience with low-ohm builds. If you are new to vaping these coils are not recommended for you. These are pre-built low resistance coils (dual coils will be below 0.1 ohm) and require a thorough knowledge of battery safety to operate them without hazard.
By purchasing this item the buyer agrees to the following terms: Twisted Messes LLC or any parties or persons representing said company, will not be held responsible for any possible or real damages or losses incurred through the use or misuse of these products. The responsibility for the use of these products is solely in the hands of the purchaser.
The Framed Staple Coil - by @SQUIDOODE
Only logged in customers who have purchased this product may leave a review.